- Variable speed motor. Roller bearings.
- A scrap rewind.
- Reverse drive switch.
- Factory Training Available ($1,400 per day plus expenses).
- Bottom supply roll assembly.
- Don't forget your lamination film!
- Non-ferrous feed tray.
- Supply roll tension knobs.
- Max. Film Roll Diameter is 6 inches.
- Interchangeable rubber rollers.
- Manufactured in the USA.
The Ledco Pre-Master Cold Roll Laminator has a variable speed setting that can laminate materials at a rate of 1 to 10 feet per minute. It has a 25 laminating width, and is perfect for laminating posters, signs and other media. Order one for your school or office today.
Note: Because of the wide variety of 220-volt outlets, this 220-volt unit may include a power cord without a plug, or require an adapter (purchased separately).
We strongly advise you to have a plug attached by a licensed electrician. We are not responsible for electrical wiring errors.
Options & Accessories:
Only available on new products shipping within the contiguous 48 states.
Covers non-wearable parts and labor. Click here for more details
Pre-Master 25" Cold Roll Laminator by Ledco Specifications:
|Laminating Roller Diameter
||0-10 feet per minute
||33" L x 17" H x 18" D
||1 mil. and up
|Max. Laminating Thickness
|Supply Roll Core Size
||110V, 3 amps, 300 watts
||220V, 3 amps, 300 watts
|Max. Film Roll Diameter
|Max. Laminating Width
||1/30 HP DC
If you have any questions or concerns, contact a customer service representative today.